Jagdpanzer 38(t) Hetzer – scale 1/6 – 3D printed kit – RC MODEL

The “Basic HW package” Hetzer kit contains screws, bearings, servos, motors, and other parts necessary for basic construction (see table below).

The “Electronics package” Hetzer kit contains the entire “Basic HW package” kit plus a pre-programmed control unit, transmitter, and other electronic components (see table below).
It also includes pre-prepared cables.
Connecting the electronics and bringing the model into operation using this package is easy, even for novice modelers.

Here you can see the building instructions:
https://www.warprints.net/1-6-scale-jagdpanzer-38t-hetzer-assembly-guide/

Model features:

• biggest surfaces are coated with XTC-3D
• steel handles
• all hatches openable
• servo controlled vertical and horizontal movement of the canon
• servo controlled recoil
• movable gunners sight coupled with gun
• realistic gun’s rifling
• realistic periscopes
• 360° rotating machinegun mount
• LED light for the front light (2x5mm LED)
• LED light for the tail light (3x3mm LED)
• tracks tensioners
• working suspensions
• detachable spare track links
• rubber rims of roadwheels
• Mg-34 machinegun
• ready for easy installation of the smoke generator

Contents of the Basic Hardware package:

Contents of the Electronics package:

Required for Assembly and Operation (not included):

To complete and run your Hetzer 1/6 Scale RC model, you will need the following items:

• Battery: 3S LiPo or 12V PB battery (minimum 5000 mAh recommended). Note: We do not sell or ship batteries.

• Charger: Suitable LiPo battery charger.

• Smoke Fluid: Standard smoke generator fluid (not included in any package; we do not ship liquids).

• Radio System: Minimum 6-channel transmitter and receiver (required only if you are not purchasing the Electronics Package).

• Assembly Tools & Materials:

  • Standard hobby tools (Phillips screwdriver, metric hex drivers).

  • Acetone or acetone-based glue (recommended).

  • CA glue (Super-glue).

  • Blue (removable) thread-locker (crucial for securing mechanical joints).

  • Modeler’s putty (required for only one joint on the entire hull).

  • Spray primer / Surfacer (approx. 1-2 cans of 500-700ml).

  • Model Paint Set.